1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Start the engine and measure the output voltage of
TPS 1 and 2 at C.T. and W.O.T.
|
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the ETC module connector.
|
3. |
Measure resistance between the ETC module terminals
1 and 2.
|
4. |
Check that the resistance is within the specification.
|
26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications
Direct control VFS[26/B]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14
(0.1 ~ 5.5, 1.42 ~ 7.82)
...
Windshield Glass. Components and
Components Location
Components
1. Windshield glass molding
2. Windshield glass
...
Rear Torsion Beam Axle. Repair
procedures
Replacement
[Disc Type]
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...