1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Remove the resonator and the air intake hose (Refer
to “Intake And Exhaust System” in EM group).
|
3. |
Disconnect the ETC module connector (A).
|
4. |
Disconnect the coolant hoses (A).
|
5. |
Remove the installation bolts, and then remove the
ETC module (A) from the engine.
|
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mu ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the rear seat (Refer to "Seat" in BD gro ...
Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...