ETC module learning procedure |
1. |
Hold the ignition key or the start button at th IG
ON position during 5 seconds.
|
2. |
Turn ignition swich OFF and then start the engine.
|
DTC codes (P0638, P2110) might be displayed if ETC
module learning procedure does not performed after replacing ETC module.
|
Side Impact Sensor (SIS). Components and Components
Location
Components
...
Thermostat. Troubleshooting
Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the thermostat gasket
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the purge control solenoid valve connector
...