1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Disconnect the crankshaft position sensor connector
(A) and remove the sensor (B) after removing the installation bolt.
|
Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary.
Also check all ignition wiring and components to be sure they are not cracked, worn
or damaged in any way. ...
Removal
Disassembly of the thermostat would have an adverse
effect, causing a lowering of cooling efficiency.
1.
...
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...