Hyundai Accent Manuals

Hyundai Accent: Installation - Camshaft Position Sensor (CMPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply the engine oil to the O-ring.
•
Insert the sensor in the installation hole and be careful not to damage.
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Installation is reverse of removal.
Camshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Removal
• DON’T remove the camshaft position sensor while the engine is running or right after engi ...

Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knoc ...

See also:

Removal
1. Remove the under covers (A). Tightening torque: 6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 7.9lb-ft) ...

Installation
1. Installation is reverse of removal. PCV Valve installation: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) ...

Rear combination light bulb replacement (5 Door)
(1) Tail light (2) Rear turn signal light (3) Back-up light (4) Stop and tail light (5) Side marker 1. Open the tailgate. 2. Loosen the light assembly retaining screws with a cross-tip screw ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com