1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Remove the intake manifold (Refer to “Intake And
Exhaust System” in EM group).
|
3. |
Disconnect the injector connector (A).
|
4. |
Remove the installation bolt (B), and then remove
the sensor from the cylinder block.
|
Rear Drum Brake. Components and Components Location
Components
1. Shoe hold down pin
2. Shoe adjuster
3. Upper return spring
4. Adjusting lever
5. Shoe
6. Adjusting spring
7. Lower return spring
8. Sh ...
Removal and Installation
Water Pump
1.
Drain engine coolant.
System is under high pressure ...