Hyundai Accent Manuals

Hyundai Accent: Installation - Knock Sensor (KS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And E ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

See also:

Inspection
1. Check the hands free remote control switch for resistance between No.4 and No.5 terminals in each switch position. [Audio + Bluetooth Hands Free] ...

Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there ...

Removal
Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper (A) and lower (B) shrouds aft ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com