Hyundai Accent Manuals

Hyundai Accent: Installation - Rail Pressure Sensor (RPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Rail Pressure Sensor Installation:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to ...

Accelerator Position Sensor (APS). Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important senso ...

See also:

Interior overview
❈ The actual vehicle may differ from the illustration. 1. Door lock/unlock button 2. Outside rearview mirror control switch* 3. Central door lock switch* 4. Power window lock button* 5. ...

Components and Components Location
Component Location 1. Audio unit 2. Tweeter speaker 3. Roof antenna (Radio) 4. Antenna cable connector 5. Front door speaker 6. Rear door speaker 7. Anten ...

Air bag - advanced supplemental restraint system
(1) Driver’s front air bag (2) Passenger’s front air bag (3) Side impact air bag (4) Curtain air bag WARNING Even in vehicles with air bags, you and your passengers must always wear the ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com