Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Remove the rear seat (Refer to "Seat" in BD group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel tank pressure sensor connector.
|
| 5. |
Remove the fuel tank pressure sensor (A) after releasing
the hooks vertically.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Front Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the front wheel alignment, always positio ...
Installation
1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring
...
Circuit Diagram
(M/T)
(A/T)
...
Hyundai Accent Manuals
© 2011-2024 Copyright www.hamanual.com