Hyundai Accent Manuals

Hyundai Accent: Installation - Injector. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Injector. Repair procedures / Installation

1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring
•
Do not reuse the used injector fixing clip.
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply engine oil to the injector O-ring.
•
Do not reuse the used injector O-ring.
•
Do not reuse the used bolt.
•
When inserting the injector, be careful not to damage the injector tip.
•
Do not reuse the support disc.
•
Do not reuse the injector rubber washer.
•
When replacing the rubber washer, the steal plate (A) part should be faced the cylinder installation part and the rubber plate (B) part should be faced the injector body part.

•
Do not reuse the combustion seal.
1.
Installation is reverse of removal.

Removal
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury ...

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...

See also:

Removal
1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical group - "Battery") ...

Removal
• Use fender covers to avoid damaging painted surfaces. • ...

Binding arbitration
Any claim or dispute you may have related to your vehicle's warranty or the duties contemplated under the warranty, including claims related to the refund or partial refund of your vehicle' ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com