Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Disconnect the variable intake solenoid valve connector
(A).
|
| 3. |
Disconnect the vacuum hoses (B) from the valve.
|
| 4. |
Remove the installation bolt, and then remove the
valve (C) from the surge tank.
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Alternator. Components and Components
Location
Components
1. Nut
2. Pulley
3. Spacer
4. Front bracket
5. Front bearing
6. Stator
7. Rotor
8. Rear bearing
9. Rear bracket
10. Brush holder assem ...
Hyundai Accent Manuals
© 2011-2024 Copyright www.hamanual.com