Inspection
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Disconnect the fuel pressure regulator valve connector.
|
3. |
Measure resistance between the fuel pressure regulator
valve terminals 1 and 2.
|
4. |
Check that the resistance is within the specification.
|
Components Operations
PCM (Power Train Control Module)
1.
The PCM (ECM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transp ...
Components and Components Location
Components Location
1. Sub frame
2. Drive shaft
3. Lower arm
4. Strut assembly
5. Steering gearbox
6. Stabilizer bar
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...