1. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
|
2. |
Remove the rear seat [LH] (Refer to “Seat” in BD
group).
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A).
|
5. |
Disconnect the fuel feed tube quick connector (B).
|
6. |
Disconnect the fuel tank pressure sensor connector
(C).
|
7. |
Disconnect the vapor tube quick-connector (D).
|
8. |
Remove the plate cover (E) after removing the installation
bolts, and then remove the fuel pump from the fuel tank.
|
Installation
1.
Installation is the reverse of removal.
...
Headlamp delay
If you turn the ignition switch to the ACC or OFF position with the headlights
ON, the headlights remain on for about 20 minutes. However, if the driver’s door
is opened and closed, the headligh ...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the ...