1. |
Turn ignition switch OFF and disconnect the negative
(-)battery cable.
|
2. |
Remove the fuel pump assembly.
|
3. |
Check motor operation by fuel pump connector (A)
connecting power(No.2) and ground(No.4)
|
1. |
Using an ohmmeter, measure the resistance between
terminals 1 and 3 of sender connector (A) at each float level.
|
2. |
Also check that the resistance changes smoothly when
the float is moved from "E" to "F".
|
Oil Pressure Switch. Repair
procedures
Inspection
1.
Check the continuity between the terminal and the
body with an ohmmeter. If there is no continuity, replace the oil pressure
switch.
...
Front Bumper. Components and Components
Location
Components
1. Front bumper cover
2. Radiator grill upper cover
3. Front bumper side bracket [ LH]
4. Front bumper side bracket [RH]
...
Removal
1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
...