Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Accelerator Pedal. Repair procedures / Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation nuts (B), and then remove the accelerator pedal module.

Accelerator Pedal. Repair procedures

...

Installation

1. Installation is reverse of removal. Accelerator pedal module installation nut: 12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 ...

See also:

Side Airbag (SAB) Module. Description and Operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airba ...

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Special Service Tools
Special Service Tools Tool (Number and Name) Illustration Use 09546-26000 Strut spring compressor Compression of co ...

Hyundai Accent Manuals

© 2011-2024 Copyright www.hamanual.com