In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
|
3. |
Remove the intake manifold (Refer to "Intake And
Exhaust System" in EM group).
|
4. |
Disconnect the injector connectors (A) and the rail
pressure sensor connector (B).
|
5. |
Remove the high pressure fuel pipe (C).
|
6. |
Remove the engine oil gauge.
|
7. |
Remove the installation bolt (D), and then remove
the delivery pipe and injector assembly from the engine.
|
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Installation
1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring
...
Reset items
Items should be reset after the battery has been discharged or the battery has
been disconnected.
Auto up/down window (See section 4)
Sunroof (See section 4)
Trip computer (See section 4)
...