In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
|
3. |
Remove the air cleaner and the air intake hose (Refer
to “Intake And Exhaust System” in EM group).
|
4. |
Disconnect the fuel pressure regulator valve connector
(A).
|
5. |
Disconnect the fuel feed tube quick-connector (B).
|
6. |
Remove the high pressure fuel pipe.
|
7. |
Remove the installation bolts (D), and then remove
the high pressure fuel pump from the cylinder head assembly.
|
Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
eng ...
Installation
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...
Removal
Passenger Compartment Junction Box
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to t ...