|
1. |
Disconnect the push rod from the master cylinder
by removing the snap pin (A) and washer.
|
2. |
Remove the clutch pedal mounting nuts (A-2ea).
|
3. |
Remove the battery and ECM.
(Refer to "Manual transaxle system" in MT group)
|
4. |
Disconnect the clutch tube (B) and reservoir hose
(A) from the clutch master cylinder.
|
5. |
Remove the clutch master cylinder by turning it clockwise
(A).
|
Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
Adjustment
Glass Adjustment
•
Check the glass run channel for damage or deterioration,
and replace ...