Clutch Pedal Inspection |
1. |
Measure the clutch pedal height (from the face of
the pedal pad to the floor board) and the clutch pedal clevis pin play
(measured at the face of the pedal pad.)
|
Ignition Lock Switch Inspection |
1. |
Disconnect 2P-connector from a ignition lock switch.
|
2. |
Disconnect the ignition lock switch. (if you can
install a tester with the switch fixed, this step can be omissible)
|
3. |
Check for continuity between terminals. (refer to
the table below)
|
Cruise control system
➀ CRUISE indicator
➁ SET indicator
The cruise control system allows you to program the vehicle to maintain a constant
speed without resting your foot on the accelerator pedal.
Thi ...
Instrument Cluster. Description
and Operation
Description
Function
Tail lamp warning buzzer
-
This function dose not operate if the vehicle equipped BCM.
-
With the tail lamp sw ...
Recommended SAE viscosity number
CAUTION
Always be sure to clean the area around any filler plug, drain plug, or
dipstick before checking or draining any lubricant. This is especially important
in dusty or sandy areas and when ...