1. |
Drain the brake fluid through the bleed plug (A).
|
2. |
Remove the clutch release cylinder assembly (C) after
removing thd tube (B) and nuts (A-2ea).
|
Troubleshooting
Troubleshooting
Starting System
Symptom
Suspect area
Remedy
Engine will not crank
Battery charge low
Charge or replace batt ...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the engine coolant temperature sensor
con ...