Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands
of fluid.
|
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
1. |
After disconnecting a cap from the clutch release
cylinder air bleeder, insert a vinyl hose in the plug.
|
2. |
Loosening the plug screw, press and release the clutch
pedal about 10 times.
|
3. |
Tighten the plug (A) during the clutch pedal pressed.
Afterwards, raise the pedal with a hand.
|
4. |
After pressing the clutch pedal 3 times more, loosen
the plug (A) and retighten it with the pedal pressed. Raise it again,
then.
|
5. |
Repeat the step 4 two or three times. (until there
is no bubble in the fluid)
|
6. |
Refill the clutch master cylinder with the specified
fluid.
|
Adjustment
How To Initialize Motor
1.
Check that the glass has been installed.
A.
Finished height adjustment.
2.
...
Tightening Torques
Item
kgf.m
N.m
lb-ft
Positive crankcase ventilation valve installation
0.8 ~ 1.2
7.8 ~ 11.8
5.8 ~ 8.7
...
Vehicle weight
This section will guide you in the proper loading of your vehicle, to keep your
loaded vehicle weight within its design rating capability. Properly loading your
vehicle will provide maximum return ...