1. |
Remove the following items;
|
2. |
Disconnect the vehicle speed sensor connector (A).
|
3. |
Remove the back up lamp switch connector (B).
|
4. |
Remove the ground cable from transaxle (A).
|
5. |
Disconnect the shift cable bracket bolts (B-3ea) after removing
the washer and pin (A).
|
6. |
Remove the tube bracket bolt (A).
|
7. |
Remove the transaxle upper mounting bolt (B-2ea) and the start
motor mounting bolt (A-2ea).
|
8. |
Remove the hood assembly.
(Refer to "Exterior (hood)" in BD group.)
|
9. |
Remove the cowl top cover.
(Refer to "Interior(cowl top cover)" in BD group.)
|
10. |
Remove the wiper motor.
(Refer to "Windshield Wiper motor" in BE group.)
|
11. |
Remove the cowl complete assembly panel (A).
|
12. |
Using the engine support fixture (Support SST No.: 09200-2S200,
Adapter SST No.: 09200-2S100, Beam SST No.: 09200-38001/3N000), hold
the engine and transaxle assembly safely.
|
13. |
Remove the mounting cover (A).
|
14. |
Remove the transaxle support mounting bracket bolts (A-2ea).
|
15. |
Remove the transaxle support mounting bracket (A).
|
16. |
Remove the under cover (A).
|
17. |
Remove the drive shaft assembly.
(Refer to "Drive shaft assembly" in DS group.)
|
18. |
Remove the clutch release cylinder assembly (B) after removing
the nuts (A-2ea).
|
19. |
Remove the roll rod support bracket (C) after removing bolt (A,B).
|
20. |
Remove the drive shaft cover (A).
|
21. |
Remove the brackets (A).
|
22. |
Remove the lower mounting bolts (A-3ea, B-2ea) of lower part of
the transaxle, and the left side cover and remove the transaxle assembly
by supporting it with a jack.
|
Key operations
Used to start the engine, lock and unlock the doors.
WARNING - Ignition key
Leaving children unattended in a vehicle with the ignition key is dangerous
even if the key is not in the ignition swit ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...
Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are
equivalent to the original factory units in diameter, rim width and offset.
WARNING
A wheel that is not the correct si ...