Oil level Check |
A check of ATF level is not normally required during scheduled
services. If an oil leak is found, perform the oil level check procedure
after repairs are completed.
|
When checking the oil level, be careful not to enter dust, foreign
matters, etc. from fill hole.
|
1. |
Remove the eyebolt (A).
|
2. |
Add ATF SP-IV 700cc to the ATF injection hole.
|
3. |
Start the engine. (Don’t step on brake and accelerator simultaneously.
|
4. |
Confirm that the temperature of the A/T oil temperature sensor
is 50 ~ 60°C(122 ~ 140°F) with the GDS.
|
5. |
Shift the select lever slowly from “P” to “D”, then “D” to “P”
and repeat one more at idle.
|
6. |
Lift the vehicle, then remove the oil level plug (A) from the
valve body cover.
|
7. |
If the oil flows out of the overflow plug in thin steady stream,
the oil level is correct.
Then finish the procedure and tighten the oil plug.
|
8. |
Put down the vehicle with the lift and then tighten the eyebolt.
|
Air bag warning label
Air bag warning labels, some required by the U.S. National Highway Traffic Safety
Administration (NHTSA), are attached to alert the driver and passengers of potential
risks of the air bag system ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the variable intake solenoid valve connector
...
Wipers and washers
A :Wiper speed control
· MIST – Single wipe
· OFF – Off
· INT – Intermittent wipe
· LO – Low wiper speed
· HI – High wiper speed
B : Intermittent wipe time adjustment
C :Wash w ...