Components Location
1. PCV adjust screw 2. Solenoid valve 3. Oil temperature sensor |
4. Accumulator 5. Low & reverse brake(LR/B) pressure flow hole 6. Under drive brake (UD/B) pressure flow hole |
1. To cooler 2. From cooler 3. Lubrication(rear) 4. Overdrive pressure 5. Reducing pressure (red2) 6. Reducing pressure (red1) 7. From damper pressure 8. To damper pressure |
9. Lubrication(front) 10. 35R clutch pressure 11. 26 brake pressure 12. From oil pump 13. To oil pump 14. Low & Reverse pressure 15. Underdrive pressure |
Recommended SAE viscosity number
CAUTION
Always be sure to clean the area around any filler plug, drain plug, or
dipstick before checking or draining any lubricant. This is especially important
in dusty or sandy areas and when ...
Muffler. Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
:
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4 ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...