Hyundai Accent Manuals

Hyundai Accent: Replacement - Transaxle Control Module (TCM). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM). Repair procedures / Replacement

1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A).
4.
Remove the TCM after removing the bolt and nut.
TCM installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side ...

Installation
1. Installation is reverse of removal. In the case of the vehicle equipped wi ...

See also:

Front Body D ( 5Door )
Hood hinge mounting hole (Ø10) Fender apron upper member tooling hole (Ø6.6) Front shock ...

Components and Components Location
Components 1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & Lateral G sensor 5. Steering angle sensor 6. ABS Warning l ...

Interior E ( 5Door )
Front pillar trim mounting hole (Ø8.5) Front pillar trim mounting hole (Ø8) Cowl cross ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com