1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)"
in this group)
|
4. |
Remove the air breather hose (A).
|
5. |
Remove the valve body cover (B).
|
6. |
Remove the plate and the detent spring (A) after removing the
bolt.
|
7. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
8. |
Remove the valve body assembly (A).
|
9. |
Disconnect the input & output speed sensor connector(A).
|
10. |
Remove the input & output speed sensor (B) after removing the
bolts(2ea).
|
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...
Removal
•
Do not spill brake fluid on the vehicle;
it may damage the paint if brake fluid does contac ...
ESC Operation Mode
ESC Hydraulic System Diagram
1.
ESC Non-operation : Normal braking.
Solenoid valve
Continuity
Valv ...