Hyundai Accent: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the oil temperature sensor connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
|
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraul ...
See also:
Removal
1.
Remove the rear roof trim.
(Refer to the Body group - Roof trim).
2.
Disconnect the antenna cable (A).
3 ...
Fuel requirements
Your new vehicle is designed to use only unleaded fuel having a pump octane number
((R+M)/2) of 87 (Research Octane Number 91) or higher.
Your new vehicle is designed to obtain maximum performance ...
Room lamp
ON (1):
In the ON position, the light stays on at all times.
DOOR (2) :
In the DOOR position, the light comes on when any door is opened regardless of
the ignition switch position.
When doors ...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com