Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)"
in this group)
|
4. |
Remove the air breather hose (A).
|
5. |
Remove the valve body cover (B).
|
6. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
7. |
Remove the solenoid valve (B) after removing the solenoid support
(A).
|
Rear Torsion Beam Axle. Repair
procedures
Replacement
[Disc Type]
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...
Installation
1.
Installation is the reverse of removal.
Use a new washer (A) whenever insta ...
EBD(Electronic Brake-force
Distribution). Description and Operation
Operation
The EBD system (Electronic Brake force Distribution) as a sub-system of
the ABS system is to control the maximum braking effectiveness by the rear wheels.
It further utilizes ...