Hyundai Accent Manuals

Hyundai Accent: Replacement - Front Hub / Knuckle. Repair procedures - Front Axle Assembly - Driveshaft and axleHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Driveshaft and axle / Front Axle Assembly / Front Hub / Knuckle. Repair procedures / Replacement

1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
3.
Remove the brake caliper mounting bolts , and then hold the brake caliper assembly (B) with wire.
Tightening torque:
78.4 ~ 98.0 N.m (8.0 ~ 10.0 kgf.m, 57.8 ~ 72.3 lb-ft)

4.
Remove the brake hose mounting bracket (A) & wheel speed sensor (B) & bracket (C).
Tightening torque (B,C):
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Remove driveshaft nut (A) from the front hub under applying the brake.
Tightening torque:
196.1 ~ 274.5 N.m (20.0 ~ 28.0 kgf.m, 144.6 ~ 202.5 lb-ft)

-
The driveshaft lock nut should be replaced with new ones.
-
After installation driveshaft lock nut, stake the lock nut using a chisel and hammer as shown in the illustration below.

6.
Remove the tie rod end ball joint from the knuckle.
(1)
Remove the split pin (A).
(2)
Remove the castle nut (B).
Tightening torque:
23.5 ~ 33.3 N.m (2.4 ~ 3.4 kgf.m, 19.4 ~ 24.5 lb-ft)

7.
Remove the lower arm (A) from the knuckle.
Tightening torque:
196.1 ~ 274.5 N.m (6.0 ~ 7.2 kgf.m, 144.6 ~ 202.5 lb-ft)

8.
Disconnect the driveshaft (A) from the front hub assembly.
9.
Loosen the strut mounting bolts and then remove the knuckle assembly (A).
Tightening torque:
137.3 ~ 156.9 N.m (14.0 ~ 16.0 kgf.m, 101.3 ~ 115.7 lb-ft)

10.
Install in the reverse order of removal.

Front Hub / Knuckle. Repair procedures
...

Disassembly
1. Remove the snap ring (A). 2. Remove the hub assembly from the knuckle assembly. (1) Install the ...

See also:

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Coolant. Repair procedures
Refilling And Bleeding Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid und ...

Meaning Of Symbols
There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service.   Symbol Meaning ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com