1. |
Install the hub bearing to the knuckle assembly.
|
2. |
Install the dust cover (A).
|
3. |
Install the hub assembly to the knuckle assembly.
|
4. |
Install the snap ring (A).
|
Good driving practices
Never take the vehicle out of gear and coast down a hill. This is extremely
hazardous. Always leave the vehicle in gear.
Do not "ride" the brakes. This can cause them to overheat and ...
Removal and Installation
1.
Disconnect the battery terminals. (Refer to Engine
and transaxle assembly in this group)
2.
Remove the air cleaner assembly. (Refer to E ...
Rail Pressure Sensor (RPS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...