|
1. |
Remove the circlip (B) from the driveshaft spline (A).
|
2. |
Remove both boot bands from the transaxle side joint(TJ) case.
|
3. |
Pull out the boot from transaxle side joint case (B).
|
4. |
While dividing joint(TJ) boot (A) of the transaxle side, wipe
the grease in TJ case (B) and collect them respectively.
|
5. |
Remove the snap ring (A) and spider roller assembly (B) from the
shaft.
|
6. |
Remove the spider assembly (B) from the driveshaft (A) using the
special tool (09495-33000).
|
7. |
Clean the spider assembly.
|
8. |
Remove the boot (A) of the transaxle side joint(TJ).
|
9. |
Using a plier or flat-tipped (-) screwdriver, remove the both
side of clamp (B) of the dynamic damper (A).
|
10. |
Fix the driveshaft (A) with a vice (B) as illustrated.
|
11. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper when the dynamic damper is removed.
|
12. |
Saperate the dynamic damper (A) from the shaft (B) carefully.
|
Interior overview
❈ The actual vehicle may differ from the illustration.
1. Door lock/unlock button
2. Outside rearview mirror control switch*
3. Central door lock switch*
4. Power window lock button*
5. ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraul ...
General Information
The Micro 570 Analyzer (Canada only)
The Micro 570 Analyzer provides the ability to test the charging
and starting systems, including the battery, starter and alternator.
...