Hyundai Accent: Reassembly
| 1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
|
| 2. |
Apply grease to the joint boot on the side of the wheel and install
the boot.
|
| 3. |
Install the clamp.
|
| 4. |
Assemble the transaxle side joint boot and bands.
|
| 5. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and snap ring (B) on the driveshaft
splines (C).
|
| 6. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
| 7. |
Install the both boot band.
|
| 8. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
|||||||||||||
| 9. |
Using the SST (09495-3K000), secure the TJ boot band.
|
Disassembly
•
Do not disassemble the BJ assembly.
•
Speci ...
See also:
Side Impact Sensor (SIS). Description and Operation
Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pilla ...
Rear Hub - Carrier. Components and
Components Location
Components
1. Rear torsion beam assembly
2. Brake assembly
3. Rear wheel hub assembly
4. Rear brake disc
5. Rear brake disc mounting screw
6. Rear wheel / T ...
Transaxle Oil Temperature Sensor. Specifications
Specifications
▷ Type: Negative Thermal Coefficient Type
Temp.[(°C)°F]
Resistance (kΩ)
(-40)-40
48.1
(-20)-4.0 ...
Hyundai Accent Manuals
© 2011-2024 Copyright www.hamanual.com