1. |
Remove the front wheel & tire.
|
2. |
Disconnect the stabilizer link with the front strut assembly after
loosening the nut.
|
3. |
Loosen the nut and then remove the tie-rod end (A) with the front
axle.
|
4. |
Loosen the nut and then remove the lower arm (A).
|
5. |
Loosen the bolt (A) and then disconnect the universal joint assembly
from the pinion of the steering gear box.
|
6. |
Remove the rubber hanger (A).
|
7. |
Remove the cross member from the body by loosening the roll rod
(A) mounting bolts and nuts.
|
8. |
Loosen the bolts & nuts and then remove the front sub frame (A).
|
9. |
Remove the stabilizer (A) from the front sub frame by loosening
the mounting bolts & nuts.
|
10. |
Disconnect the stabilizer link (A) with the stabilizer bar by
loosening the nut.
|
11. |
Remove the bushing (A) and the clamp (B) from the stabilizer bar.
|
12. |
Installation is the reverse of removal.
|
Removal
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the intake manifold
and connect a vacuum pump to the nipple on the intake manifold.
· At Col ...
Output Speed Sensor. Description and Operation
Description
The output speed sensor (A) is a vital unit that measures the rate of
rotation of the transaxle's turbine shaft and output shaft, and delivers the
readings to the TCM. The se ...