Hyundai Accent Manuals

Hyundai Accent: Sub Frame. Repair procedures - Front Suspension System - Suspension SystemHyundai Accent: Sub Frame. Repair procedures

Hyundai Accent RB (2010-2018) Service Manual / Suspension System / Front Suspension System / Sub Frame. Repair procedures

Replacement

1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.
Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

3.
Loosen the nut and then remove the tie-rod end (A) with the front axle (B).
Tightening torque :
23.5 ~ 33.3N.m(2.5 ~ 3.4kgf.m, 19.4 ~ 24.6lb-ft)

4.
Loosen the nut and then remove the lower arm (A).
Tightening torque :
58.8 ~ 70.6N.m(6.0 ~ 7.2kgf.m, 43.4 ~ 52.1lb-ft)

5.
Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box.
Tightening torque :
32.4 ~ 37.3N.m(3.3 ~ 3.8kgf.m, 23.9 ~ 27.5lb-ft)

•
Lock the steering wheel in the straight ahead position to prevent the damage of the clock spring inner cable when you handle the steering wheel.
•
Must be replaced with new bolts when assembling. (SEAL-LOCK has been processed)
SEAL-LOCK Specifications: MS721-39 "TYPE-D" Product: ND industries 1193S
6.
Remove the rubber hanger (A).
7.
Remove the cross member from the body by loosening the roll rod (A) mounting bolts and nuts.
Tightening torque :
53.9 ~ 63.7N.m(5.5 ~ 6.5kgf.m, 39.8 ~ 47.0lb-ft)

8.
Loosen the bolts & nuts and then remove the front sub frame (A).
Tightening torque :
Sub frame mounting bolt & nut
156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)
Sub frame stay mounting bolt
44.1 ~ 53.9N.m(4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)

9.
Installation is the reverse of removal.

Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. 3. Check th ...

Rear Suspension System
...

See also:

Installation
1. Reassemble the hands free switch after connecting the connector. 2. Reassemble the steering wheel. 3. Reasse ...

To decrease the cruising speed
Follow either of these procedures: Push the SET- switch and hold it. Your vehicle will gradually slow down. Release the switch at the speed you want to maintain. Push the SET- switch and re ...

Side Body C ( 5Door )
Front side member tooling hole (Ø12) Fender apron upper reinforcement tooling hole (Ø7) ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com