|
1. |
Slide the sensor-valve unit through the valve hole of the rim.
Hold the sensor against the rim and the rubber grommet against the sealing
surface.
|
2. |
Insert the nut over the valve stem and then tighten the nut.
|
3. |
Continue to tightening the nut until contact with the rim and
then tighten to 3.5 ~ 4.5Nm.
|
4. |
Check that the sensor is firmly attached to the rim.
|
5. |
Carry out inflation / pressure correction and then fit valve cap.
|
6. |
Install the tire. (Refer to "Tire Installation")
Sensor ID Writing (Wireless)
Sensor ID Writing
|
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mu ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Installation
•
Thoroughly clean all parts to be assembled.
•
...