1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Install the SRSCM with the SRSCM mounting nuts.
|
4. |
Connect the SRSCM harness connector.
|
5. |
Install the rear heating joint duct and floor console. (Refer
to the Body group - "Console")
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the SRSCM, confirm proper system operation:
|
Removal
1.
Remove the mounting bolt and disconnect the horn connector, then
remove the horn (A).
...
Installation
1.
Installation is reverse of removal.
Fuel tank band
installation nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~
39.8 lb-ft ...
Projected Dimensions ( 4 Door )
Front side member tooling hole (Ø6.6)
Side cover mounting hole
(B/B’: Ø6.6/ Ø8.6)
...