|
1. |
Install the new front impact sensor.
|
2. |
Tighten the front impact sensor mounting bolt.
|
3. |
Connect the front impact sensor connector.
|
4. |
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
|
5. |
Install the front bumper.
(Refer to the Body group - "Front bumper")
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the Front Impact Sensor, confirm proper system
operation:
|
Installation
1.
Install the power window switch module.
2.
Install the door trim panel after reconnecting the relevant connectors
...
Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...
Removal
Door Mirror Turn Signal Lamp
1.
Remove the mirror (A) from the mirror holder. Be careful not to
damage to the clip.
2.
Remove ...