Hyundai Accent Manuals

Hyundai Accent: Installation - Side Impact Sensor (SIS). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / SRSCM / Side Impact Sensor (SIS). Repair procedures / Installation

Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt then connect the side impact sensor connector.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
2.
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
3.
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
4.
Reconnect the battery negative cable.
5.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
Side Impact Sensor 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the d ...

Schematic Diagrams
...

See also:

Engine Number
1. Engine fuel - G : Gasoline 2. Engine range - 4 : 4 cycle 4 cylinder 3. Engine developmen ...

Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons other than the AUTO button. In this case, the system works sequentially according to the order of buttons selected. Wh ...

Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety location. 2.Connect connection hose (9) of the compressor directly to the tire valve. 3.Plug the compressor power c ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com