1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
3. |
Connect the clock spring harness connector to the clock spring.
|
4. |
Install the steering column shroud.
|
5. |
Set the center position by setting the marks between the clock
spring and the cover into line. Make an array the mark (▶◀) by turning
the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.
|
6. |
Install the steering wheel. (Refer to the Steering System group
- "Steering Column and Shaft")
|
7. |
Connect the driver airbag (DAB) module connector, and then install
the driver airbag (DAB) module on the steering wheel.
|
8. |
Secure driver airbag (DAB) with the new mounting bolts.
|
9. |
Connect the battery negative cable.
|
10. |
After installing the airbag, confirm proper system operation:
|
35R Clutch Control Solenoid Valve(35R/C_VFS). Description and Operation
Description
35R clutch control solenoid valve(35R/C_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the 35R clutch.
...
Seat Belt Buckle Switch (BS). Components and
Components Location
Components
...
Driving in the rain
Rain and wet roads can make driving dangerous, especially if you’re not prepared
for the slick pavement. Here are a few things to consider when driving in the rain:
A heavy rainfall will make ...