Hyundai Accent Manuals

Hyundai Accent: Removal - Passenger Airbag (PAB) Module. Repair procedures - Airbag Module - Restraint (Depowered)Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Depowered) / Airbag Module / Passenger Airbag (PAB) Module. Repair procedures / Removal

1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to the Body group - "Crash pad")
3.
Disconnect the passenger airbag connector (A) and remove the PAB mounting bolt (B).
4.
Remove the crash pad.
(Refer to the Body group - "Crash pad")
Replace the crash pad which is damaged while PAB is deployed.
5.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.

The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

Passenger Airbag (PAB) Module. Repair procedures
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

See also:

Components and Components Location
Components Location 1. PCV valve 2. Canister 3. Purge control solenoid valve (PCSV) 4. Fuel tank pressure sensor (FTPS) 5. Canister close valve (CCV) 6. Fuel ...

Engine number
The engine number is stamped on the engine block as shown in the drawing. ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A) after disconnecting the trip switch connector(B). ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com