Hyundai Accent: Variant coding
After replacing the SRSCM with a new one, must be performed the “Variant
Coding” procedure.
1. |
On SRSCM variant coding mode, the airbag warning lamp
is periodically blinking (ON: 0.5sec., OFF: 0.5sec.) until the
coding is normally completed.
|
2. |
If the variant coding is failed, DTC B1762 (ACU Coding
Error) will be displayed and the warning lamp will be turned
on.
In this case, perform the variant coding procedure again
after confirming the cause in “DTC Fault State Information”.
Variant Coding can be performed up to 255 times, but if
the number of coding work exceeds 255 times, DTC B1683 (Exceed
Maximum coding Number) will be displayed and SRSCM must be replaced.
|
3. |
If the battery voltage is low (less than 9V), DTC B1102
will be displayed. In this case, charge the battery before anything
else, and then perform the variant coding procedure.
DTC B1762 (ACU Coding Error) and B1102 (Battery Voltage
Low) may be displayed simultaneously.
|
|
Variant coding Procedure
1. |
Ignition "OFF", connect GDS.
|
2. |
Ignition "ON" & Engine "OFF" select vehicle name and airbag system.
|
3. |
Select Variant coding mode.
|
4. |
Follow steps on the screen as below.
|
1) Initial ACU Variant Coding screen
2) VIN Code entering screen
3) Variant coding's proceeding screen-1
4) Variant coding's proceeding screen-2
5) Variant coding is completed
1) This screen is opened when you try the variant coding again
on the SRSCM which has bee performed variant coding.
2) Screen of communication failure
|
■ Off-line type on GDS (This can be used when not connecting to internet)
1) Initial ACU Variant Coding screen
2) ACU Coding Code entering screen
3) Screen of rechecking ACU Coding code's entering
4) Variant coding's proceeding screen-1
5) Variant coding's proceeding screen-2
6) Variant coding is completed
1) This screen is opened when you try the variant coding again
on the SRSCM which has been performed variant coding.
|
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary pur ...
See also:
Introduction
With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture.
The system of compressor and sealing compound effectively and comfortably seals
most punctures in a passenger c ...
Special Service Tools
Special Tools
Tool (Number and name)
Illustration
Use
09861-31100
Sealant cut-out tool
Cutting windshield sealant
( ...
Vehicle data collection and event data recorders
This vehicle is equipped with an event data recorder (EDR). The main purpose
of an EDR is to record, in certain crash or near crash-like situations, such as
an air bag deployment or hitting a road ...