Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Removal

•	Removal of the airbag must be performed according to the precautions/ procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front bumper. (Refer to the Body group - "Front bumper")

3.	Remove the washer reservoir. (Refer to the Body Electrical group - "Washer motor") [Right side only]

4.	Remove the front impact sensor mounting bolt (A).

5.	Disconnect the front impact sensor connector (B).

6.	Remove the front impact sensor.

Front Impact Sensor (FIS). Repair procedures

...

Installation

• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

See also:

Underdrive Brake Control Solenoid Valve(UD/B_VFS). Description and Operation
Description Underdrive brake control solenoid valve(UD/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the underdrive ...

Removal and Installation
1. Disconnect the battery terminals. (Refer to Engine and transaxle assembly in this group) 2. Remove the air cleaner assembly. (Refer to E ...

Removal
1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. (Refer to ...

Hyundai Accent Manuals

© 2011-2024 Copyright www.hamanual.com