1. |
Disconnect the stop lamp switch connector (A).
|
2. |
Adjust the brake pedal height (A) as illustration below.
|
3. |
Adjust the stop lamp switch clearance (B) and brake pedal free
play.
|
4. |
Connect the stop lamp switch connector.
|
1. |
Disconnect the stop lamp switch connector (A).
|
2. |
Pull the locking plate (A) as indicated by the arrow.
|
3. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
4. |
Fix the brake pedal arm and insert fully the stop lamp switch
as hiding contact part.
|
5. |
After inserting, turn the stop switch (A) 45° clockwise, and then
assemble locking plate (B) by pushing.
|
6. |
Confirm the gap between stop lamp switch and bracket.
|
7. |
Connect the stop lamp switch connector.
|
Fuel Tank Pressure Sensor
(FTPS). Specifications
Specification
Pressure [kPa (kgf/cm², in
H2O)
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
...
Side Airbag (SAB) Module. Components
and Components Location
Components
...
Sunroof Motor. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim. (Refer to the BD group - " Roof trim")
...