ETC module learning procedure |
1. |
Hold the ignition key or the start button at th IG
ON position during 5 seconds.
|
2. |
Turn ignition swich OFF and then start the engine.
|
DTC codes (P0638, P2110) might be displayed if ETC
module learning procedure does not performed after replacing ETC module.
|
Special Service Tools
Special Service Tools
Tool(Number and Name)
Illustration
Use
09495-3K000
Band installer
Installation of ear type bo ...
Valve Body. Components and Components Location
Components Location
1. PCV adjust screw
2. Solenoid valve
3. Oil temperature sensor
4. Accumulator
5. Low & reverse brake(LR/B) pressure flow hole
6. Und ...
Inspection
Rotor
1.
Check that there is continuity between the slip rings
(C).
2.
Check that there is no continuity between the s ...