Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands
of fluid.
|
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
1. |
After disconnecting a cap from the clutch release
cylinder air bleeder, insert a vinyl hose in the plug.
|
2. |
Loosening the plug screw, press and release the clutch
pedal about 10 times.
|
3. |
Tighten the plug (A) during the clutch pedal pressed.
Afterwards, raise the pedal with a hand.
|
4. |
After pressing the clutch pedal 3 times more, loosen
the plug (A) and retighten it with the pedal pressed. Raise it again,
then.
|
5. |
Repeat the step 4 two or three times. (until there
is no bubble in the fluid)
|
6. |
Refill the clutch master cylinder with the specified
fluid.
|
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - & ...
Relay Box (Passenger Compartment). Schematic Diagrams
Circuit Diagram
...
Closing the fuel filler lid
1. To install the cap, turn it clockwise until it “click” one time. This indicates
that the cap is securely tightened.
2. Close the fuel filler lid and push it in lightly making sure that it is ...