Hyundai Accent: Cleaning
| 1. |
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will
damage the insulation wipe these parts with a cloth only.
|
| 2. |
Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory
and sol-vent will wash lubrication from the clutch.
|
| 3. |
The drive unit may be cleaned with a brush moistened
with cleaning solvent and wiped dry with a cloth.
|
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
Starter Relay. Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay(A).
3.
Using an ohmmeter, check t ...
See also:
Components and Components Location
Components Location
1. Overdrive clutch (OD/C)
2. One way clutch (OWC)
3. Low & Reverse brake (LR/B)
4. Underdrive brake (UD/B)
5. 26 brake (26/B)
6. 35R ...
Removal
In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
...
Control System Composition
Fault Diagnosis
Features a fail-safe mechanism that prevents dangerous situations from
developing in the event of a transaxle failure. The limp home mode engages if
the transaxle mal ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com