Replacement
[ M/T ] |
|
1. |
Using a screwdriver or remover, remove the console upper cover
(A).
|
2. |
Remove the console tray mat (A).
|
3. |
After loosening the mounting bolt and clips, then remove the floor
rear console (A).
|
4. |
Using a screwdriver or remover, remove the floor console front
bezel (A).
|
5. |
Disconnect the connectors (A).
|
6. |
After loosening the mounting bolts and nut, clips, then remove
the floor front console (A).
|
7. |
Installation is the reverse of removal.
|
[ A/T ] |
|
1. |
Remove the gear knob (A).
|
2. |
Using a screwdriver or remover, remove the console upper cover
(A).
|
3. |
Disconnect the connector (A).
|
4. |
Remove the console tray mat (A).
|
5. |
After loosening the mounting bolt and clips, then remove the floor
rear console (A).
|
6. |
Using a screwdriver or remover, remove the floor console front
bezel (A).
|
7. |
Disconnect the connectors (A).
|
8. |
After loosening the mounting bolts and nut, clips, then remove
the floor front console (A).
|
9. |
Installation is the reverse of removal.
|
|
1. |
Using a screwdriver or remover, remove the rear console cover
(A).
|
2. |
After loosening the mounting screws, then remove the armrest assembly
(A).
|
3. |
Installation is the reverse of removal.
|
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the
turn signals, move the lever up or down (A). Green arrow indicators on the instrument
panel indicate which turn si ...
Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety
location.
2.Connect connection hose (9) of the compressor directly to the tire valve.
3.Plug the compressor power c ...
Yaw-rate and G Sensor. Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the front seat (LH) assembly.
(Refer ...