Hyundai Accent: Crankshaft Position Sensor (CKPS). Troubleshooting

This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals.

Generally CkPS signal is used to detect the piston's position and CMPS signal is used to detect the Top Dead Center of each cylinder.

Crankshaft Position Sensor (CKPS). Specifications

Specification Item Specification Coil Resistance (Ω) 774 ~ 946 [20°C (68°F)] ...

Crankshaft Position Sensor (CKPS). Schematic Diagrams

Circuit Diagram (M/T) (A/T) ...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat (Refer to "Seat" in BD gro ...

Injector. Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...