Hyundai Accent: Disassembly
| 1. |
Disconnect the M-terminal (A) on the magnet switchassembly.
|
| 2. |
After loosening the 2 screws (A), detach the magnetswitch
assembly (B).
|
| 3. |
Loosen the through bolts (A).
|
| 4. |
Remove the rear bracket (A) and brush holderassembly
(B).
|
| 5. |
Remove the yoke (A).
|
| 6. |
Remove the packing (A), lever plate (B), lever (C)
and the armature (D).
|
| 7. |
Press the stopper (A) using a socket (B).
|
| 8. |
After removing the stop ring (A) using stopper pliers(B).
|
| 9. |
Remove the stop ring (B), stopper (A), overrunningclutch
(C) and armature (D).
|
| 10. |
Reassembly is the reverse of disassembly.
|
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4l ...
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
See also:
Antenna Coil. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing
3 sc ...
Inspection
1.
Check each part for cracks, damage or wear, and replace
the coolant pump assembly if necessary.
2.
Check the bearing for damage, abnorma ...
Special Service Tools
Special Service Tools
Tool
(Number and name)
Illustration
Use
09200-38001,3N000 (Beam)
09200-2S100 (Adapter)
09200-2S200 (Supporter)
...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com