Hyundai Accent Manuals

Hyundai Accent: Disassembly - Front Hub / Knuckle. Repair procedures - Front Axle Assembly - Driveshaft and axleHyundai Accent: Disassembly

1.
Remove the snap ring (A).

2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the front knuckle assembly (A) on press.
(2)
Lay a suitable adapter (B) upon the hub assembly shaft.
(3)
Remove the hub assembly (C) from the knuckle assembly (A) by using press.

3.
Remove the hub bearing inner race from the hub assembly.
(1)
Install a suitable tool (A) for removing the hub bearing inner race on the hub assembly.
(2)
Lay the hub assembly and tool (A) upon a suitable adapter (B).
(3)
Lay a suitable adapter (C) upon the hub assembly shaft.
(4)
Remove the hub bearing inner race (D) from the hub assembly by using press.

4.
Remove the dust cover (A).

5.
Remove the hub bearing outer race from the knuckle assembly.
(1)
Lay the hub assembly (A) upon a suitable adapter (B).
(2)
Lay a suitable adapter (C) upon the hub bearing outer race.
(3)
Remove the hub bearing outer race from the knuckle assembly by using press.

6.
Replace hub bearing with a new one.

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Reassembly
1. Install the hub bearing to the knuckle assembly. (1) Lay the knuckle assembly (A) on press. (2) ...

See also:

Headlamp delay
If you turn the ignition switch to the ACC or OFF position with the headlights ON, the headlights remain on for about 20 minutes. However, if the driver’s door is opened and closed, the headligh ...

Cleaning
1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation wipe these parts with a cloth only. ...

Adjustment
Adjusting the control cable 1. Set room side AT lever(shift lever) and automatic transaxle side manual control lever to "N" position. 2. ...

Hyundai Accent Manuals


В© 2011-2024 Copyright www.hamanual.com